Important Notes

• If truck is equipped with a proportioning valve a relocation bracket kit is required. Add in configuration / checkout.
• Dodge Rams were manufactured with two different front sway bar link setups. Some were mounted ABOVE the axle bracket and some BELOW. If your model's sway bar links are above the axle bracket, a sway bar link kit is required. Add in configuration / checkout.
• If your vehicle is equipped with a top mounted overload/helper spring, 4 longer U-bolts may be required.
• Factory block is replaced with 5" block and add-a-leaf combo to obtain a level stance.
• Factory Rear Sway Bar? If your vehicle is equipped with a factory rear sway bar, a rear sway bar link kit is recommended. Add in configuration / checkout.
• Factory wheels fit when paired with factory / original equipment tire size.
• Will NOT fit models built before February 9, 1994 due to track bar stud size.
• Steering Stabilizer Required! Due to the factory drag link flip when installing this kit the factory steering stabilizer cannot be reinstalled.
• Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
• ATTN State of California Consumers warning: Cancer and Reproductive Harm