Valid Till:
Fitment
| Years | Make | Model | Drive |
|---|---|---|---|
| 2018-2025 | Jeep | Wrangler JL | 4WD |
Features
- Race-inspired performance for increased vehicle stability
- Improved dynamic roll control and low-speed damping
- Dramatic improvement in on-road comfort and off-road performance
- Optimized fitment for unobstructed suspension travel and articulation
- 13” stroke, Front and Rear
- Adjustable crossover for True Dual-Rate
- 4.5” lift, +/- 1.25” adjustability using quick adjust snap rings
- Coated, Booted and Sealed, oversized Gimbal Lock Bearings mount and maintain shock orientation
- JL specific springs, and shock tuning
- Falcon 3.3 series Quick Adjust tuning
- Designed for standard 3.0” springs
- Refreshed Speed Bumps silently provide 4X the bottoming resistance
- Bolt on ¼” laser cut reinforced Coil Over brackets
Quick Specs
- 16 Hours install time
- Part Number : 1367005/1367001
Important Notes
- REQUIRES aftermarket wheels w/ 4.75” backspacing or less — or Wheel Offset Adapter Pair (JL | JT 1.75”: # 1057000) (JK 1.25”: # 1055000) for stock wheels — NOT INCLUDED may REQUIRE two pair.
- Models with plastic bumpers REQUIRE removal of bumper-to-fender wind deflector/splash guards to fit 35” or larger tires.
- Sport/Sahara fenders REQUIRE 3” Front and 2.5” Rear Bump Stop Strike Pad Extensions/Shims (INCLUDED) to fit 35” tires.
- Sport/Sahara fenders REQUIRE 3.5” Front and 4” Rear Bump Stop Strike Pad Extensions/Shims to fit 37” tires. REQUIRES an additional 0.5” Bump Stop Strike Pad Shim Kit (# 1959300) — NOT INCLUDED.
- Rubicon fenders REQUIRE 2.5” Front and 3” Rear Bump Stop Strike Pad Extensions/Shims (INCLUDED) to fit 37” tires.
- Aftermarket high fenders REQUIRED to fit 39”+ tires. Bump Stop Strike Pad Extensions/Shims requirements will vary based on setup including wheel/tire combination, shock collapsed length, and fenders. Installer MUST check for clearances. We recommend an additional 0.5” Bump Stop Strike Pad Shim Kit (# 1959300) — NOT INCLUDED.
- Long Arm Kits REQUIRE cutting/removal of factory control arm bracketry to install JL | JT | JK Long Arm Brackets or TJ LCG Long Arm Brackets. Stretch Kits REQUIRE cutting/removal and/or relocating of factory bracketry to install Front Long Arm Brackets, Rear Upper Coil Spring Perch Relocation Brackets and Rear Upper Track Bar Relocation Bracket and Rear Lower Bump Stop Landing Pads. Refer to instructions for details.
- Alignment REQUIRED.
- Not compatible with 2-door models
TeraFlex 1367005/1367001 Alpine RT Coilover Upgrade Kit
2018-2025 Jeep Wrangler JL 4WD
2018-2025 Jeep Wrangler JL 4WD
- SKU :
- Part Number :
As low as
$7,899.99
As low as
$7,899.99
