Pro Comp 55298 2" Rear Coil Spring Set

Components

Important Notes

• Driveline modifications may be required for height increases over 1.5" due to increased driveline angles. Transfer case SYE (Slip Yoke Eliminator) kit and CV rear drive shaft required for Long Arm Applications. Rubicon models will require CV drive shaft w flange adapter (not avail from Pro Comp).
• Vehicles with Auto Trans will require removal of front skid plate when using transfer case lowering hardware.
• All ride height increases are approximate and will vary due to vehicle specification (Engine size, factory options, trail equipment, etc).
• Coil spacer 55496 can be used to increase front ride height by .75".
• Vehicle will require alignment after kit is installed.
• Front cambolt kit 20-65226 is recommended for caster angle adjustments. In most cases, reducing positive caster to the minimum factory specification will reduce or eliminate the potential for steering wheel shimmy.
• Rear cambolt kit 20-65225 can be used for tuning pinion angle for minor driveline vibration correction.